Illuminate your print and your printer!

See my improved model here: https://www.printables.com/model/965894-led-lighting-bracket-for-sidewinder-x12

Searching for an easy to print solution?

This one is designed for the Artillery Sidewinder X2. Made of 3 Parts, Cable can be mounted left or right. You may need to replace the 2 screws by longer variants (+4mm). No additional screws or glue needed.

Update V2:

• Update vertical strive. moved to the inner side so that the ribbon cable is not bent
• Add a simple cable guide
• Middle (LED) part is not changed

Used with SK6812 RGBW LED IP30 144LEDs/Pixels/m 5V (for example BTF-LIGHTING RGBW RGBNW Naturweiß SK6812

Fits for exactly 25 LEDs

Be sure to use a 144er Variant without IP65/67 protection - the dimensions are different

You can connect them directly to your printers board (instead of the extruder LED). This means further firmware adaptions - or you connect them to your AirCookie WLED Project

If you are really fancy you can setup your effects or status illumination together with Klipper firmware

Tell us what was your solution?

Example klipper config snippet, if it is directly connected to your board

[neopixel printled]pin: <YOUR-PIN>color_order: GRBWchain_count: 25initial_RED: 0.0initial_GREEN: 0.0initial_BLUE: 0.0initial_WHITE: 0.5

Have fun.

I would be very happy to see your makes of that!
And feel free to comment.

Like it?