LED Light CR-10/CR-10s Fan Blower Mount (No Screws Needed) 3D Printer Model
The file 'LED Light CR-10/CR-10s Fan Blower Mount (No Screws Needed) 3D Printer Model' is (stl) file type, size is 244.9KB.
The file 'LED Light CR-10/CR-10s Fan Blower Mount (No Screws Needed) 3D Printer Model' is (stl) file type, size is 244.9KB.
I was looking for a light that could go over my prints while printing but couldn't find anything so I decide to design my own. Also, I made it so you don't have to use any screws. It lights up your prints while your printing.
Directions:
Mount onto the 2 extra screw holes on the fan blowers.
For the LED's:
To power the LED's I cut the two wires to the cooling fan for the extruder. Then I soldered just the positive wire to the fan coolers positive wire. Next, I ran the ground wire all the way next to the control box and connected a switch to it. Then connected another wire to the switch and ran it back and connected it to the fan coolers ground wire. I plan on making a little box for the switch to fit in that can be mounted down with the screws from the spool holder.
Parts:
| LED_CR10S_Fan_Attachment_Mod.stl | 634.6KB |
