Light bar for the Prusa i3 MK2/S and MK3/S available in single light, dual light, and MMU2 compatible dual light versions. Mounts are designed to fit 9x17mm aluminum u-channel and have a hollow interior that is used to route the wires down the back of the printer frame for a clean look. Mounts also include an opening to insert a power switch. The LED strips can be powered by the printer power supply. Use a 12V (MK2) or 24V (MK3) LED strip depending on which printer you have.
Go to PrusaPrinters for assembly instructions.
Links to PrusaPrinters:
Single Mount
Dual Mount
MMU2 Dual Mount
Bear Upgrade
Versions: (Each available in Single, Dual, and Dual MMU2)
Standard: Attaches to the hexagonal holes in the stock z-axis tops.
No Switch: Same as Standard with no hole for the power switch. Either use an external switch or always have the light on with the printer.
Z-Axis Top: Integrates the Prusa z-axis top pieces into the light bar for a more sturdy mount. Remove the stock z-axis tops and replace with this light bar mount.
Z-Axis Top No Switch: Same as Z-Axis Top with no hole for the power switch.
Bear Upgrade: Light bars for the Bear Upgrade frame kit
Purchase hardware kit here If the kit is out of stock, check back in a few days.
| Dual_Mount.stl | 126.6KB | |
| Dual_Mount_Bear_Upgrade.stl | 167.5KB | |
| Dual_Mount_No_Switch.stl | 125.8KB | |
| Dual_Mount_Z-Axis_Top.stl | 142.5KB | |
| Dual_Mount_Z-Axis_Top_No_Switch.stl | 141.5KB | |
| Left_MMU2_Mount.stl | 67.3KB | |
| Left_MMU2_Mount_Bear_Upgrade.stl | 82.7KB | |
| Left_MMU2_Mount_No_Switch.stl | 66.4KB | |
| Left_MMU2_Mount_Z-Axis_Top.stl | 74.8KB | |
| Left_MMU2_Mount_Z-Axis_Top_No_Switch.stl | 73.8KB | |
| Right_MMU2_Mount.stl | 57.1KB | |
| Right_MMU2_Mount_Bear_Upgrade.stl | 80.0KB | |
| Right_MMU2_Mount_Z-Axis_Top.stl | 64.6KB | |
| Single_Mount.stl | 101.8KB | |
| Single_Mount_Bear_Upgrade.stl | 155.2KB | |
| Single_Mount_No_Switch.stl | 101.0KB | |
| Single_Mount_Z-Axis_Top.stl | 130.2KB | |
| Single_Mount_Z-Axis_Top_No_Switch.stl | 129.2KB |
