LED Holder 3D Printer Model
The file 'LED Holder 3D Printer Model' is (stl,obj) file type, size is 484.0KB.
The file 'LED Holder 3D Printer Model' is (stl,obj) file type, size is 484.0KB.
Trying to find a good LED curing station for my resin and it turns out there are none. So I turned on fusion 360 and crafted these stackable LED holders. This will allow you to create a "Light Box". More to come once they are printed and edited. Please let me know how they work for you and post your makes!
12.22.20- updated the male end of the post on the frame. They seemed to be slightly too large to fit in the holes without some post-work.
v2.0 is sharp edges no holes
v2.1 has radii on all edges plus holes for wires. Also made the dovetail slightly deeper to make it easier to install the led strips.
If you are using cut-to-length led strips the strip will go directly between the posts and the wires can come out the back.
12.23.20- End caps made. they do fit snug. you can scale down to like 98% to make them fit a little less tight. I did notice that the led strips are a little hard to get in there and the ones that I am installing are not waterproof. which means they are not encased in silicone. I will be redesigning to accommodate those.
12.24.20- Added a new design that should accommodate the waterproof LED strips. Will be printing and testing tonight.
| LED_End_Cap_v1.0.stl | 149.5KB | |
| LED_Hold_v4.0.obj | 48.3KB | |
| LED_Strip_Holder_Base_v1.stl | 220.1KB | |
| V3.0_LED.stl | 1.8MB |
