Hi all!
Because certain issues when printing bridges and problematic areas with my Leapfrog Creatr I decided to design a colling system for the printer´s nozzle.
An add on is the increased printing speed.
I needed about 6 versions (someones with sub-versions) but finally I´m happy with this final design.
This design can use a 50x50mm fan or a 60x60mm one, I´ll suggest a 50x50mm one (easy to find over ebay, I bought this one "Delta AUB0512HB 50x50x15mm 5015 DC 12V 0.15A Brushless Fan 2-pin 2510 Connector"), but there is a choice to use a 60x60mm kind, but it will crash a little with the right rear stepper.
I also added in both sides holes to insert a couple of 5mm leds so we can see better the printing area :D
| 50x50_fan_grid_1.stl |
| 50x50_fan_grid_2.stl |
| 60x60_fan_grid.stl |
| Leapfrog_Creatr_Nozzle_cooler_by_Zabana.rar |
| Nozzle_cooler_fan_50x50_intlet.stl |
| Nozzle_cooler_fan_60x60_intlet.stl |
| Nozzle_cooler_outlet.stl |
| Nozzle_cooler_outlet_mirrored.stl |
| piece_1.stl |
| piece_1_mirror.stl |
| piece_2.stl |
| piece_2_mirror.stl |
| piece_3.stl |
| piece_3_mirror.stl |
| piece_4.stl |
| piece_4_mirror.stl |
| piece_5.stl |
| Top_halves.stl |
