Latching Bolt 3D Printer Model
The file 'Latching Bolt 3D Printer Model' is (stl) file type, size is 105.3KB.
The file 'Latching Bolt 3D Printer Model' is (stl) file type, size is 105.3KB.
After adding a door to my shed I wanted to keep one of the doors held shut unless needed. The square bolts on Thingiverse only worked horizontally so I designed one which could rotate and hold the bolt in position.
The small brace can be used to hold the other side of the bolt or printed in a different orientation to increase the strength of the assembly.
The holes are sized for #10 screws though the chamfers are a little shallow for their heads.
The bolt is 5/8" inches in diameter, the hole in the pictures was cut using a 5/8" paddle bit and has a fairly tight fit while still sliding.
Please note, this is not intended to act as a security device!
| bolt-body.stl | 93.4KB | |
| bolt-brace.stl | 47.9KB | |
| bolt-complete.stl | 221.4KB | |
| bolt-housing.stl | 79.5KB |
