Securely latching variable size print in place box.
This is a the first in a series of latching print in place boxes, it will securely hold shut even if dropped. There is a grove in the lower haft for an optional seal made of 1.75mm TPU filament. This will NOT make the box water proof merely more water resistant.
To start off I have uploaded sixteen versions of this box delineated by internal dimension. The size is listed at the end of the file name by _width_length_height in millimeters. I can upload other sizes in the future if requested. The box can be any reasonable width or length but must be between 43mm and 70mm in height.
Check out the new Type 2 https://www.thingiverse.com/thing:6092869
| Latch_Box_Type1_100_100_50.stl | 2.0MB | |
| Latch_Box_Type1_100_50_43.stl | 1.9MB | |
| Latch_Box_Type1_100_50_50.stl | 1.9MB | |
| Latch_Box_Type1_100_80_60.stl | 1.9MB | |
| Latch_Box_Type1_110_80_70.stl | 1.9MB | |
| Latch_Box_Type1_120_60_50.stl | 1.9MB | |
| Latch_Box_Type1_120_60_60.stl | 1.9MB | |
| Latch_Box_Type1_140_140_70.stl | 2.1MB | |
| Latch_Box_Type1_54_30_43.stl | 2.0MB | |
| Latch_Box_Type1_60_120_70.stl | 1.9MB | |
| Latch_Box_Type1_60_140_43.stl | 2.0MB | |
| Latch_Box_Type1_60_60_43.stl | 1.9MB | |
| Latch_Box_Type1_70_96_60.stl | 1.9MB | |
| Latch_Box_Type1_80_80_60.stl | 1.9MB | |
| Latch_Box_Type1_96_70_50.stl | 1.9MB | |
| Latch_Box_Type1_96_74_70.stl | 1.9MB | |
| print_in_place_hinge_test_015.stl | 278.0KB |
