This is a bottle holder for 0.5L bottles for drying my water-bottle at work.
The hole for the bottle is 4cm in diameter so it should fit most bottles.
I used 4mm Poppel finèr (plywood?), any 4mm wood should work.
3 or 5 mm will probably work but will look a bit off... you can then use sandpaper to smooth out the jagged edges.
Assemble with care, the hinge cuts might need to be softened with water.
| FlaskeBox.dxf | 166.2KB | |
| FlaskeBox.svg | 15.7KB |
