I made a Laser Cut acrylic paint bottle holder as I couldn't find one of this style that doesn't take alot of room and mounts to wall. 20 inches by 12 inches.
YOU WILL NEED TO BUY 2.75 MM PLY WOOD TO MAKE THIS.
The tongue and grove laser joints require this dim wood.
Holes to hold paint bottles are 1 1/2" dia.
No glue required if you cut it right. Make sure wood is perfectly flat on cutting table to get accurate cuts so laser joints work.
Cut on my Thunder Laser Nova 35 at 35 mm per sec at 65% power.
Designed on Onshape.
Note part 18 mates with part 11
Please post pics of made ones
| Part_Studio_1.dxf | 18.1KB | |
| Part_Studio_10.dxf | 18.3KB | |
| Part_Studio_11.dxf | 17.4KB | |
| Part_Studio_12.dxf | 12.6KB | |
| Part_Studio_13.dxf | 12.6KB | |
| Part_Studio_14.dxf | 12.6KB | |
| Part_Studio_15.dxf | 12.6KB | |
| Part_Studio_16.dxf | 12.6KB | |
| Part_Studio_17.dxf | 12.6KB | |
| Part_Studio_18.dxf | 12.6KB | |
| Part_Studio_2.dxf | 38.3KB | |
| Part_Studio_3.dxf | 33.9KB | |
| Part_Studio_4.dxf | 15.6KB | |
| Part_Studio_5.dxf | 18.5KB | |
| Part_Studio_6.dxf | 18.6KB | |
| Part_Studio_7.dxf | 18.4KB | |
| Part_Studio_8.dxf | 18.5KB | |
| Part_Studio_9.dxf | 18.3KB |
