Laser Cut Simple Top Hinged Front Cover For Enclosure On Replictor
The file 'Laser Cut Simple Top Hinged Front Cover For Enclosure On Replictor' is (dxf,svg) file type, size is 5.7KB.
The file 'Laser Cut Simple Top Hinged Front Cover For Enclosure On Replictor' is (dxf,svg) file type, size is 5.7KB.
This thing is a laser cut 3mm Acrylic front door for a Makerbot Replicator. It uses Hinges (http://www.thingiverse.com/thing:757329) and attached to the Case without any new holes or other modifications. Hinges have a simple removable 3mm hinge pin, and install with existing holes in the case.
Hinges attach to the Acrylic panel with M3 screws and these printable stress relieving washers (http://www.thingiverse.com/thing:755320).
This simple design lets gravity do the work of holding it closed, but you could add a latch using as simple variation of this latch (http://www.thingiverse.com/thing:755496)
| ReplicatorFrontCover.dxf | 15.8KB | |
| ReplicatorFrontCover.svg | 7.5KB |
