15.04.2019 Update

• Added new Rear/Motor bracket! Should work with trucks where the motor(s) are installed (usually rear). I say should because I didn't yet tested the design on my boards and also it is hard to predict if it will work for you because every board is different. Let us know if it works for your board and which. If needed, I can do adjustments.

18.05.2018 Update

• Few small changes to light holder part (just a bit narrower and 1mm shorter tip to tip).
• Added new dual bracket! Works great with wider trucks as the ones from TorqueBoards (DIYElectricSkateboard) or on LEIFTECH eSnowboard!

(The dual bracket you can see on the image is milled out of 1.5mm carbon fiber plate and I manually filed the edges all around.)

This is a CAD drawing of a brackets (holders) for ShredLights (lights for skateboards/longboards). Probably the best lighting system at the moment, check them out at shredlights.com!

I designed standard bracket and single (penny) bracket in Fusion 360 using original brackets as a template. Shipping cost for ordering just the spare set of brackets would be too expensive.

I haven't yet made (milled or 3D printed) a sample from the drawing so consider this a work in progress. I would appreciate your comments if you make this and/or spot any flaws in the design.

Thanks and keep shredding! :)