Decided to increase my build height to 345mm when I replaced the acrylic panels, I've modified the panel design to use standard 800mm rods and increased the placements for ends tops and cables so that the cabling can be equally distributed up all three sides.
This requires some small notiches made on the plate under the print bed to allow the cable to pass.
Upgrades I recommend and have done to my machine are:
Carbon fibre arms.
Glass bed - currently 2mm double sided tape to orginal build plate.
Fan modified to come on only when hot end is above 35c (Thanks to DC42's latest 1.09o-dc42 firmware)
I should add. XT = extra tall.
| panels_605mm.dxf |
| panels_605mm.skp |
