Lasercut paint caddy based on a design I saw online (not on Thingiverse). I sized mine to fit my 2oz airbrush paints. Designed for 1/8" plywood. Back piece is too large for my laser cutter so I split it in two. I'm using K40 Whisperer so my paths are colored red. Adjust the line widths/colors as necessary for your laser cutter.
This design is still in progress:
In my case I wanted to make an acrylic cover (laser cut and bent), but I want to upgrade my ventilation system before doing so. I included a two piece plywood cover with finger joints, but you'll need to figure out the hinges for it.
For the carrying strap I used some leftover leather that I had lying around.The screw holes for the carrying strap is a 6mm diameter cut. It's actually a little small for the 1/4" bolts I had around, but it still ended up working out okay.
My drawer is a little undersized as I accidentally took the faces from my 1/4" design. I'll add those SVGs in a bit.
| Back_Plate.svg | 5.3KB | |
| Back_Plate_cut1.svg | 3.5KB | |
| Back_Plate_cut2.svg | 3.7KB | |
| Bottom_Panel.svg | 2.4KB | |
| Cover_Front.svg | 2.1KB | |
| Cover_Top.svg | 2.1KB | |
| Divider_shelf_1.svg | 2.4KB | |
| Divider_shelf_2.svg | 2.4KB | |
| Front_face.svg | 2.3KB | |
| Left_wall.svg | 5.5KB | |
| Right_wall.svg | 5.5KB | |
| Shelf.svg | 3.8KB | |
| Vert_Divider_1.svg | 3.3KB | |
| Vert_Divider_2.svg | 3.3KB |
