The file 'Laser Cut Nixie Tube Clock Powered By Arduino' is (dxf,ino) file type, size is 21.46 KB.
I bought all the goodies to make a nice Nixie clock from Taylor Electronics, but I didn't have a nice case for it. It took me about 6 hours to design, cut, and re-cut parts until I had something I was happy with. I disabled the I2C master on the first TES 1361 SmartNixie board and replaced it with an Arduino Nano board connected in the unused RTC connector on the bottom of the backplane board. I poll the GPS RTC board via I2C to get the time and then send command over the I2C bus to the SmartNixie boards to display the digits.
1392.dxf |
255mm.dxf |
smart_nixie.ino |