Laser Cut Linear Rail For DSLR Camera Free Download

Description Files (6)

Summary

This is a linear rail for a dslr camera made from 1/8" think laser cut acrylic and some 12mm linear rails/bearings. The hole on the center sliding piece for the camera mount fits a 1/4-20 bolt (standard for camera mounts). If you are planning on mounting this to a tripod the bottom piece should have another layer to it or use some other kind of reinforcement to reduce the slight amount of sag in the middle from the weight from the linear rails. I would have chosen smaller rods/bearings but I already had these. On a table it works fine.

The rails are held on to the baseplate with some 4-40 screws and nuts that go through the orange endplates and the base.

The sliding plates are spaced apart with some threaded nylon hex standoffs that I had available. I can try to hunt down the specifics if requested.

12mm round rod:
http://www.amazon.com/gp/product/B002BBJ0CA/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1

Linear Bearings:
http://www.amazon.com/gp/product/B00CGR8WUU/ref=oh_aui_detailpage_o06_s00?ie=UTF8&psc=1

brackets:
http://www.amazon.com/gp/product/B00C4PBMMY/ref=oh_aui_detailpage_o06_s00?ie=UTF8&psc=1

Camera_Slide_Bracket.DXF	25.9KB
Camera_Slide_Bracket_BasePlate.DXF	23.7KB
Camera_Slide_Bracket_Outside.DXF	25.9KB
Camera_Slide_Bracket_TOP.DXF	21.9KB
Camera_Slide_Moving_Base_Bottom.DXF	20.1KB
Camera_Slide_Moving_Base_Top.DXF	26.9KB

Laser Cut Linear Rail For DSLR Camera

Summary

Tags

You might also like