Laser Cut Arduino Enclosure Open Top
The file 'Laser Cut Arduino Enclosure Open Top' is (cdr) file type, size is 82.4KB.
The file 'Laser Cut Arduino Enclosure Open Top' is (cdr) file type, size is 82.4KB.
I needed this, and desided to make it just a little bit wider.
The top is now open, so you can have easy accsess.
++ this is now in A4 sheet and devided for K40 laser and similar...
from teabot (cudos and like):
3) Cut the design from 3mm acrylic. Slot the pieces together - excluding the lid!
4) Slide in your Arduino board, USB port first. Secure the board to the base plate with fixings of your choosing. I used some M3 bolts with insulating washers. But you could use PCB stand-offs if you wish - consider the alignment of the boards with the port cut-outs at this point.
5) Attach the top plate and secure with four 30mm M3 bolts. If you are likely to be removing the lid frequently then an elastic band maybe more useful than bolts. Be careful not to over tighten as this may shatter the acrylic.
| arduino_a4.cdr | 51.0KB | |
| arduino_bottom.cdr | 28.8KB | |
| arduino_side.cdr | 19.1KB | |
| arduino_topp_open.cdr | 28.6KB |
