Thought I would Make myself an arcade controller with built in Raspberry Pi 3. This is just a very basic design, cut from 5mm acrylic and then used ink jet printable vinyl to make the decals.
I did notice that the top left button was too close to the side for the back tightener so I just put a bit of glue to hold it in place.
Designed in Fusion 360 and this is my first laser cut project but hope to make more soon.
All pieces are glued together with Industrial Strength superglue except for the back that uses 4 M3 screws with nuts (T slots are on the sides but hidden by the decals).
| Bottom_Panel.dxf | 3.7KB | |
| Controller_Panel.dxf | 4.1KB | |
| Front_Panel.dxf | 2.8KB | |
| Left_Panel.dxf | 4.2KB | |
| Rear_Panel.dxf | 3.7KB | |
| Right_Side_Panel.dxf | 3.7KB |
