I did not see any planters that I liked so I made my own using egon's Torqued Vase http://www.thingiverse.com/thing:312670
Print without infill and top. I used 5 layers on the bottom and sides to make it sturdier. I tried with spiral and it came out way too thin but feel free to play with the settings.
Once both parts are printed I drilled some drain holes (they don't need to be perfect, as you can tell by my pictures) in the bottom of the planter and then glued both pieces together with some extra filament in between them to allow water to run out. If someone wants to take the time to redesign this with holes and spacers already in the design feel free but a drill and some super glue was good enough for me. I also added to gravel to the bottom to allow the water to drain better.
| Torqued_Base.stl | 1.8MB | |
| Torqued_Planter.stl | 1.9MB |
