Lanard Triple Shot 15mm Barrels Chamber 3D Printer Model
The file 'Lanard Triple Shot 15mm Barrels Chamber 3D Printer Model' is (stl,step) file type, size is 1.9MB.
The file 'Lanard Triple Shot 15mm Barrels Chamber 3D Printer Model' is (stl,step) file type, size is 1.9MB.
A cylinder replacement that allows the Lanard Triple Shot to fire one shot at a time form a 6 shot cylinder using 15mm OD barrel material.
Requires 6 x 7mm Ball Bearings, 6 x 4mm Ball bearings, 6 4mm diameter springs, and 6 M2.6 x 8mm screws, and one M2.6 x 16 screw to hold the pin at the top to the cam at the bottom.
Place the 7mm ball bearings in the cylinder one at a time and use a small piece of thin scotch tape to hold them in. once they are all in insert the cam into the hole at the bottom and secure it at the pin to the top of the cam with the 16mm screw. Then you can carefully remove the thin pieces of tape holding in the ball bearings. Insert the spring and then a 4mm ball bearing in to one of the holes on the side and push the ball bearing in and screw an 8mm screw into the screw hole to lock it in. Repeat for each of the 6 ball bearing holes. The 15mm OD barrel should be able to be pushed in with some force, but it's a fairly tight fit so you may need to adjust the hole horizontal expansion in your slicer.
| Cam.stl | 2.0MB | |
| Collar.stl | 586.0KB | |
| Pin.stl | 157.5KB | |
| Triple_shot_barrels.step | 1.5MB | |
| Turret.stl | 2.2MB |
