Lack Enclosure Filament Guide 3D Printer Model
The file 'Lack Enclosure Filament Guide 3D Printer Model' is (3mf,stl) file type, size is 32.4KB.
The file 'Lack Enclosure Filament Guide 3D Printer Model' is (3mf,stl) file type, size is 32.4KB.
Filament Guide For Ikea Lack Enclosure
I created this to solve the problem of the fialment bunching up when printing tall objects on my Mk4.
The bunching was caused by the small passthrough hole I originally used to feed the filament through the center of the lack enclosure. This design lets the filament feed into the enclosure with enought room for it to not bind or bunch up on tall prints.
I printed it in PETG, 0.2 layer height and it took approx 3 hours to print.
Insert fits a hole cut to the size: 12mm x 262mm
The dimensions and hole size needed are in the photos.
It will stick out slightly below the tabletop so there is enough room to put some hot glue or simial. (Althought its not needed)
| FilamentGuide_3MF.3mf | 18.9KB | |
| FilamentGuide_STL.stl | 77.4KB |
