Front knuckle/spindle for the Kyosho Triumph buggy.
Tap the mounting screw with a M2.6 tap. Ream the pivot with a 4 mm drill bit. Carefully bore the axle hole with a 7 mm drill bit.
NOTE: I have not yet printed to confirm dimensions but this should be very close. I expect that I may need to tweak the hole sizing for the M2.6 hole. As always, an original part or a Shapeways produced part in nylon/ABS is going to be best for this type of part.
I may update this design to change to a M3 screw hole for the turnbuckle as the M2.6 screws on the older Kyosho buggies can be difficult to find.
| TRIUMPH_FR_SPINDLE_LH.stl | 156.5KB | |
| TRIUMPH_FR_SPINDLE_LH.stp | 75.1KB | |
| TRIUMPH_FR_SPINDLE_RH.stl | 156.5KB | |
| TRIUMPH_FR_SPINDLE_RH.stp | 74.9KB |
