Update 9/22/20 - I realized that the spacer blocks the bit and drill storage built into the bottom of the jig. The new version has a cutout to access the storage section. I left the old version in here in case you store your bits separately.
The platform of the Kreg K4 pocket hole jib is 1 inch in height from the table surface, which makes balancing larger work pieces difficult. This spacer raises the platform up by 1/2 inch so that it is the same height as a standard 2x4 to help support the work piece.
I have the Ender 3 v2 whose print bed is too small to fit the entire length of the spacer in one continuous print, so I had to split the piece into two using a half lap. The two parts self-align by using the screw hole pattern. The full length is 270mm so you can print the full piece if you have a CR-10 or similar with a bed size. The STL for this is also included.
PARTS LIST
PRINT TIME
About 11 hours, 131g of Filament for both parts
| height_spacer_A.STL | 34.7KB | |
| height_spacer_A_with_cutout.STL | 44.1KB | |
| height_spacer_B.STL | 15.5KB | |
| height_spacer_B_with_cutout.STL | 19.8KB | |
| height_spacer_full.STL | 34.3KB | |
| height_spacer_full_with_cutout.STL | 44.0KB |
