Covers the opening at the bottom of each tower on a Kossel XL 2020 printer. This design is inspired by Kossel Linear Drive Belt Lower Cover from peaberry. The X-, Y- and Z-covers each have a hole for wires. I have also uploaded a design without wire holes. You need a total of 12x M4 8mm long screws, and M4 (hammer) T-nuts to mount the covers.The photo shows the printer with the X- and Y-covers attached and the Z-cover just printed. Also check my Kossel 2020 XL heated bed holder / adapter.
| Kossel_XL_base_corner.stl | 187.2KB | |
| Kossel_XL_base_X-corner.stl | 188.0KB | |
| Kossel_XL_base_Y-corner.stl | 188.0KB | |
| Kossel_XL_base_Z-corner.stl | 188.8KB |
