Kohler Command CH Series Pod Filter Adapter 3D Printer Model
The file 'Kohler Command CH Series Pod Filter Adapter 3D Printer Model' is (STL) file type, size is 328.0KB.
The file 'Kohler Command CH Series Pod Filter Adapter 3D Printer Model' is (STL) file type, size is 328.0KB.
if STL loads in super small, scale it up 2540%, my cad software does not always play nice for some reason
Pod filter adapter for the carbs found on Kohler CH series engines, should work for accelerator pump or non accelerator pump carbs. Pictured it is on a CH20S engine. Designed to work with a 2" mount UNI dual element pod filter. This adapter also raises the bowl vents a good amount to prevent fuel from splashing out of the bowl vents and flooding your engine during rough offroad use.
I honestly don't know what material is best for this. It's at your discretion to decide what is best for occasional contact with petroleum products. PLA+ has worked for me so far
Make sure you get all the supports out of the little vent tubes, i found you can push them out with a small allen wrench or piece of wire.
A short video of it: https://www.youtube.com/watch?v=3qImXTvDZKw
| KOHLER90.STL | 1.1MB |
