My nephew had some new cabinets put in, the contractor did not use the clips that came with the glass cabinet doors and just put nail and glue, did not look good. Went to Lowes and Home Depot and found these clips on the doors. Neither Lowes or Home Depot would sell replacements so I measured them up and created the models and printed a set. Works well.
No raft or supports needed, just print with the large flat side down. I ended up using 20% in-fill for some strength. I printed a set in PLA and PETG. The PETG is stronger and the clear PETG looks like the molded part.
| glass_holder.stl | 36.7KB |
