The mudflap on my kingsong 16X tore off with an offroad session so obviously I wanted to replace it.
The original one is big and not that great to look at so I went on and made a new design.
I started with making the blank bumper which is the same as the front bumper.
The original design is not very 3d printable so I made some adjustments to make it easier to print.
I then used that bumper to make a mudflap.
It prevents my backpack from getting dirty after (or during) heavy rainfall.
USE ANY FLEXIBLE MATERIAL AND NOT PLA!
It will break the already fragile plastic standoffs on the inner shell in case of a crash.
| 16X_Front_bumper_original.stl | 441.8KB | |
| 16X_Front_bumper_printable.stl | 442.6KB | |
| 16X_Mudflap_replacement.stl | 879.3KB |
