This is a simple box to adapt the kings 12V accessory panel that you get in a lot of their bundles into a simple box with an anderson plug.
My friend sleeps outside my campervan so I run a cable out to him with this box so he can use an electric blanket and charge his phone.
Simple enough to wire up, Photo shows how I ran the wires.
Screws used can be M4 without heat inserts or M3 if you have heat inserts.
I used M3 Heat inserts on the top with M3x5 Screws
Then I used M4 Screws for the bottom that thread strait into the anderson plug. I used my soldering iron to heat the screws and screwed them until they were almost flush.
Recommend to print with PETG or higher as this box is usually kept within a car.
Design by eugene4981 Modelled by Me (f3nici)
| 12V_Accessory_Box.stl | 68.1KB |
