Kayak Pedal Drive T-Track (Wilderness/Perception) 3D Printer Model
The file 'Kayak Pedal Drive T-Track (Wilderness/Perception) 3D Printer Model' is (stl) file type, size is 8.8KB.
The file 'Kayak Pedal Drive T-Track (Wilderness/Perception) 3D Printer Model' is (stl) file type, size is 8.8KB.
I wanted a rod caddy to sit on top of my pedal drive while handling fish, changing out lures, etc. I decided to step it up a level by making it a t-track so other accessories could be added and not limit it to a single use.
It does not slide over the top, IF you print it will slide on from the side.
t-track v1 - Will fit between the raised alignment markings
rod caddy v1 - is a little loose but added notch and a rubber band and your good to go. Solid medium rubber band double wrapped and it won't go anywhere. working on additional alternatives. future changes may include higher rails and clip locks
Printed and proofed out with PLA. ABS would make for better longevity but may not allow for the needed flex to get it onto the helix drive
Designed and tested on the Wilderness Systems Helix PD.
It also fit the Perception Pilot PD (same drive)
NOTE: for obvious reason (it's made of plastic) use at your own risk. I take no responsibility for lost/damaged items or injury from the use of this.
| Helix_Mount_Rod_Steady_v1.stl | 5.7KB | |
| Helix_Mount_T-Track_v1.stl | 37.4KB |
