Kawasaki Ninja 300 Fender Eliminator 3D Printer Model
The file 'Kawasaki Ninja 300 Fender Eliminator 3D Printer Model' is (stl) file type, size is 25.9KB.
The file 'Kawasaki Ninja 300 Fender Eliminator 3D Printer Model' is (stl) file type, size is 25.9KB.
Fender Eliminator for 2013+ Kawasaki Ninja 300
It uses all the stock lights/wiring so no need to mess anything up.
Attaches using the stock bolts.
Licence plate holes sized and spaced to suit QLD/Australian plates, should accommodate a wide range of sizes though.
Instructions -
Print the main bracket and feed & mount the lights in the side holes, might need some filing to get them just right.
Add the stock licence light on the front with the spacer to close the gap. Should be able to get a screwdriver in through the rear hole to tighten the screw.
Feed the wiring through the top hole and into the bike.
Attach to the bike using stock bolts.
Once installed, check the lights work and attach the back and bottom plate to seal it all up.
| Ninja300_Backing_plate.stl | 1.4KB | |
| Ninja300_Bottom_plate.stl | 10.2KB | |
| Ninja300_Fender_Bracket.stl | 78.6KB | |
| Ninja300_Stock_Light_spacer_12mm.stl | 12.8KB |
