This is my very first attempt ever to make a 3D model. It is not symmetrical, I know. But it works.
I got the K8403 Led kit for the Vertex 3D / K8400 printer. The kit comes with some double sided tape and they kept dropping off. These small objects clamp the led strips in place and keeps them there. You will need to get some longer M5 bolts at your local construction store! I think I used 16mm ones, but they also might have been 20mm.
I printed 5 of these (2 at the back side and 1 at each other side) and removed the vertical M5 bolt and nuts of the small corner pieces. Put a led strip in the clamp, slide a nut into the bottom of the printed part and tighten the longer bolt. Rinse and repeat.
| led_holder.stl | 44.4KB |
