After trying a few fan stuff, I built those.
There is a left and right mount (mirror) for 80mm standard fans.
Cooling is not any more a problem with those big boys.
Important: You need to have good quality fans that can work at low speed (Noctua for example).
Another advantage is that there is less noise due to the slightly increased flow.
I just put some duck tape to fix those mounts on the frame.
Add also 4 Long M6 Bolts
Slicer: You will need to update your slicing parameters for Fan speed, otherwise you can have no extrusion... or the bed temperature that will go down too much too...
Eletronic: No problem about the Mosfet found on the 3DRAG/K8200 Board, it can supports it without any issue.
| Support_Droit_Ventilateur_80_V1.fcstd | 36.2KB | |
| Support_Droit_Ventilateur_80_V1.stl | 14.0KB | |
| Support_Gauche_Ventilateur_80_V1.fcstd | 36.3KB | |
| Support_Gauche_Ventilateur_80_V1.stl | 14.0KB |
