UPDATE:
Added a tubing holder by sensor.
I hated the filament runout on K1 max. I run out of filament, and it took so much time just to remove and then put new filament. So, I made my own setup and put the sensor outside.
One picture shows my cut on the side of the plastic cover to run wires from sensor.
the sensor bracket I keep loose so it can rotate but it can be secure for your angle. Also, I keep my tubing not in the sensor but loose so if filament runs out it easy to pull it out with removing tubing from sensor.
I use Brass inserts 2) 3mm and 1) 4mm. but also, I made so you can use nuts.
Bracket.stl | 1.7MB | |
Bracket.stp | 93.1KB | |
Filament-center.stl | 4.7MB | |
Filament-center.stp | 342.5KB | |
Sensor_Mount.stl | 1.4MB | |
Sensor_Mount.stp | 76.9KB |