Gimbal guard for the new Jumper T20 radio.

V1: Print it with at least 2 walls, laying on the top side, then you won't need supports. Stick holes and clamp are too tight for my taste. Leave a comment why you like it better than the V2 if you want me to iterate on this version.

V2 fits a lot better and has nicer clamping mechanism, but prints longer and needs supports. See images for support settings (i used cura 5.0.0, but it should not matter).

Notes on support settings for easy cleanup: Depending on your printer's bridging capabilities, you might get away with support placement "touching buildplate". Using at least 3 walls (for standard 0.4mm nozzle) and any bottom layer pattern oriented along the bridging direction will give you the best results (for my setup: 0.2mm layer height, "lines" bottom pattern, "-45,45" pattern orientation will produce lines along the upper clamp gap, when the model is oriented along the x axis). If you don't want to fiddle with pattern orientation, bumping up the wall count or using "concentric" pattern will work as well (tradeoff is longer print times for walls or more infill / worse top layers with concentric).

Thanks to TehZeno for testing the support setup on their Voron 2.4!