Jumper T16 Carry Case 3D Printer Model
The file 'Jumper T16 Carry Case 3D Printer Model' is (STL) file type, size is 23.3MB.
The file 'Jumper T16 Carry Case 3D Printer Model' is (STL) file type, size is 23.3MB.
Carry Case for the Jumper T16!
This has been a challenge since I had to print this many times myself.
After failed prints, broken printer components, design revisions of the case, this model is ready for printing.
Check my entire design collection on Cults3d.com
https://cults3d.com/en/users/bopiloot/creations
Update 17-07: Printing the revision of the case, If everything goes well than the final model will be available tomorrow.
Update 18-07: read the Post-printing section!!
Components needed:
spring ID4 OD5 see drawing
2x M2x14 CS screw
Ø12 tube (carbon or anodised alu)
The fillet of the case is removed compared to the pictures to have a flat base to start printing, afterward the corner can be sanded. For that reason print with 100% infill.
| T-16_Carry_Case_r1_Base.STL | 21.5MB | |
| T-16_Carry_Case_r1_Buckle.STL | 2.7MB | |
| T-16_Carry_Case_r1_Latch.STL | 11.0MB | |
| T-16_Carry_Case_r1_Lid.STL | 16.9MB | |
| T-16_Carry_Case_r1_Nut.STL | 1.7MB |
