Maj 31/08/2021 add Male 2 & 3 pins connectors
I designed these JST Connectors to fit cable terminals, to connect my home made filament sensor to the Ender 3 v2 PCB.
If you don't have a JST kit around but cable terminals and you can't wait this is for you...
I designed the female connector 2.4mm longer to encapsulate the entire terminal tubings, so did I with the male connectors. My designs are voluntary minimalist to print easily without support. It works very well you can even solder wires on the Male connector !
Anyway you shouldn't expect a long lasting if you plug and unplug them often, cause the crushed tubes will obviously loosen faster than the springs of the genuine design.
You can modify any design using the RAW.step files provided. In Freecad Part Design workbench, create a body, drag and drop the object on the body and you can use the tools as usual.
PCB connectors and Male connector:
Female connectors :
You're done
| JST_XH_2pins.stl | 27.0KB | |
| JST_XH_2pins_Male.stl | 10.2KB | |
| JST_XH_2pins_Male_RAW.step | 154.8KB | |
| JST_XH_2pins_PCB.stl | 15.3KB | |
| JST_XH_2pins_PCB_RAW.step | 75.3KB | |
| JST_XH_2pins_RAW.step | 129.8KB | |
| JST_XH_3pins.stl | 22.2KB | |
| JST_XH_3pins_Male.stl | 12.0KB | |
| JST_XH_3pins_Male_RAW.step | 183.8KB | |
| JST_XH_3pins_PCB.stl | 20.6KB | |
| JST_XH_3pins_PCB_RAW.step | 80.4KB | |
| JST_XH_3pins_RAW.step | 123.3KB |
