Joystick 3D Printer Model
The file 'Joystick 3D Printer Model' is (stl) file type, size is 1.1MB.
The file 'Joystick 3D Printer Model' is (stl) file type, size is 1.1MB.
This is a joystick concept I have been playing with for a while. :-)
It is based on 3 potentiometers and an Arduino Nano.
I have tested it and it works very well. :-)
In the pictures I also added rubber bands to force it to the center.
The glue holds the rubber bands in place. Yes, it’s not a delicate solution, but it works. :-)
I also added a photo of a test with a drawing arm. I invented a very difficult way of drawing. :-)
You also need:
4X Bearing 624ZZ (diameter 13mm, thickness 5mm, hole 4mm)
1x Bearing 635 (diameter 19mm, thickness 6mm, hole 5mm)
6x M4x20mm and 6 nuts
4x M3x20mm and 4 nuts
2X M3x10mm and 2 nuts
3x potentiometers (B1 P160KN3K) I used 50K Ohm because I had those. See print screen for dimensions
Printed in PET-G, 0.2mm resolution
| bearing_house_stick.stl | 1.4MB | |
| bearing_house_stick_double.stl | 1.4MB | |
| gear_O_bracket.stl | 485.7KB | |
| gear_potmeter.stl | 152.4KB | |
| gear_stick_bracket.stl | 638.6KB | |
| mountingplate.stl | 968.0KB | |
| O_bracket.stl | 1.4MB | |
| pod_pin_stick.stl | 383.1KB | |
| stick.stl | 1.2MB | |
| stick_bracket.stl | 1.4MB | |
| U_bracket.stl | 1.2MB |
