STL DIMENSIONS ARE IN INCHES.
I recreated a brass pushbutton latch seen in this youtube video: https://youtu.be/M_Inc_NAn3I?t=818
My plan is to incorporate two of these into a portable toolbox.
Additional hardware required:
-0.063" rod (for the pivot shaft) - cut to width of catch.
-Spring < Ø 0.2" < 1/4" - adjust spring length for push strength.
For installation instructions check out the page for the original brass catch: https://www.rockler.com/jewelry-box-catch
| bottom_latch_half.STL | 72.4KB | |
| rotating_part.STL | 162.1KB | |
| top_latch_half.STL | 147.6KB |
