Simple design for a jewelry box. The one shown I had to sand down the bottom inset a little for the top to fit but I went back and tweaked the design so you shouldn't have to sand anything!
Some tips if you are going to print this with wood PLA filament, I think it looks much better without any sanding the striations in the print make it look better, IMHO.
Update: Sep 3, 2019 - I added a cross cutout to the top and a cross piece that you can inset into it. I stained the top still but left the cross untouched to give it a nice two-tone look.
| Bottom_JewelryBox.STL | 5.4KB | |
| Cross.STL | 2.2KB | |
| JBox_Cross_Top.STL | 91.6KB | |
| Top_JewelryBox.STL | 15.5KB |
