JEEP Wrangler – 52 Part Fully Printable 3D Printer Model
The file 'JEEP Wrangler – 52 Part Fully Printable 3D Printer Model' is (stl) file type, size is 1.5MB.
The file 'JEEP Wrangler – 52 Part Fully Printable 3D Printer Model' is (stl) file type, size is 1.5MB.
I made this JEEP Wrangler model in Fusion 360 and printed on my Biqu B1.
The body, vinsch and rearview mirrors was printed with bed support.
Everything else was printed without support.
5mm steel axle L=80mm or use the printable one
| 5mm_AXLE_L80mm.stl | 32.6KB | |
| JEEP_Body.stl | 1.3MB | |
| JEEP_chassi.stl | 213.8KB | |
| JEEP_door_handle.stl | 22.5KB | |
| JEEP_front_turn_signals.stl | 18.6KB | |
| JEEP_fuel_cap.stl | 27.6KB | |
| JEEP_grill.stl | 743.0KB | |
| JEEP_headlights.stl | 25.5KB | |
| JEEP_hinge.stl | 6.5KB | |
| JEEP_left_rearview_mirror.stl | 59.8KB | |
| JEEP_rear_window.stl | 5.7KB | |
| JEEP_right_rearview_mirror.stl | 59.8KB | |
| JEEP_rim.stl | 462.0KB | |
| JEEP_roof_rack.stl | 405.5KB | |
| JEEP_roof_rack_lights.stl | 160.7KB | |
| Jeep_side_window_1.stl | 5.9KB | |
| Jeep_side_window_2.stl | 5.6KB | |
| JEEP_side_window_3.stl | 5.7KB | |
| JEEP_spare_wheel_holder_1.stl | 88.4KB | |
| JEEP_spare_wheel_holder_2.stl | 90.3KB | |
| JEEP_surf_board.stl | 292.9KB | |
| JEEP_surf_boarf_fin.stl | 10.8KB | |
| JEEP_taillights.stl | 81.5KB | |
| JEEP_tire.stl | 573.3KB | |
| JEEP_Vinsch.stl | 260.9KB | |
| JEEP_windshield.stl | 5.7KB |
