Jeep Grand Cherokee WK Switch Plate / Panel 3D Printer Model
The file 'Jeep Grand Cherokee WK Switch Plate / Panel 3D Printer Model' is (stl) file type, size is 369.3KB.
The file 'Jeep Grand Cherokee WK Switch Plate / Panel 3D Printer Model' is (stl) file type, size is 369.3KB.
Switch panel that replaces the factory cubby on left side of dash. Fits five 3/4 inch switches made to fit Hella switch #H61923001. The cheap push in rocker switches on Amazon will fit but don't like to stay in, (well at least the ones i have) The part is 1/8 thick. Should fit Jeep Grand Cherokee Wk 2008-2010.
Possibly Jeep Commander of the same years. (If someone tries let me know.)
Actual part dimensions 144mm long, 58mm tall, 3mm thick, holes 20mm.
Not perfect but works good for now.
The tabs are a tight fit be careful removing it after test fitting, once the switches are in you will more than likely have to push it out from the back.
---The square hole one has NOT been tested I was asked to add it. Hole size is 25mm x 48mm---
| Switch_Panel_Square_v1.stl | 892.5KB | |
| Switch_Panel_v8.stl | 362.6KB |
