J Head MK8 Carriage For Da Vinci 3D Printer Model
The file 'J Head MK8 Carriage For Da Vinci 3D Printer Model' is (stl) file type, size is 2.5MB.
The file 'J Head MK8 Carriage For Da Vinci 3D Printer Model' is (stl) file type, size is 2.5MB.
Update 16/feb/16
Added 40mm. vent bracket (optional: instead of 40mm shroud).
Corrected main body and bushing brackets tolerances for easy adjustment.
Improved MK8 for easy loading filament and lock tension spring easy system.
Added rear fan funnel instead induction sensor. (optional)
Added end stop/sensor bracket for funnel and induction sensor.
WARNING:
Please adjust on EEPROM the Z home value to -16.000. Then you can adjust the bed position to print.
On Davinci 1.0 with a single fan, Use the original 5V. fan with its original connection for cooling the hotend (lateral fan).
For the front fan, use a new 12V. line. and a new 12V. fan.
Dont connect bouth fans to the same connection although they are the same voltage.
Thanks.
Update 03/feb/16
Added 40mm shroud fan.
General corrections in mk8 extruder.
Carriage assembly for MK8 extruder and J Head hotend.
It is used with 12mm bushings. (outside diameter).
Use metal sheet screws or TAP the plastic for use with stove screws.
Use 30mm 5V. fan for the hot end shroud.
Optional:
Replace the glass for aluminum to use the inductive sensor.
Serch on youtube for install the sensor on the PCB board.
| 30mm_fan_shroud.stl | 654.0KB | |
| 40mm_fan_shroud.stl | 505.9KB | |
| air_tunnel.stl | 430.8KB | |
| end_stop.stl | 210.4KB | |
| lock_bushing_brackets.stl | 1.6MB | |
| main_body.stl | 2.3MB | |
| mk8_01.stl | 1.1MB | |
| mk8_02.stl | 999.4KB | |
| mk8_03.stl | 224.4KB | |
| plastic_bushings.stl | 453.9KB | |
| sensor_bracket.stl | 91.6KB | |
| sensor_with_endstop_bracket.stl | 766.1KB | |
| vent_bracket.stl | 551.0KB |
