This is my original idea for an IWB holster for our pocket .380s. But this could work for any single stack 9mm or .380.
Made for a P3AT, compatible with an LCP. This concept can be extended to almost any other gun.
Print it in PLA, with plenty of support.
After removing support, with your unloaded gun at hand, heat up the plastic until it becomes very malleable. You can use an heat gun or your cookers. Just be careful not to burn your fingers.
When the plastic is hot, place the (unloaded) gun inside the holster and model the holster one part at time.
| p3at_iwb_10.stl | 29.2KB |
