IUninker Pi Case Din Rail Mount 3D Printer Model
The file 'IUninker Pi Case Din Rail Mount 3D Printer Model' is (stl) file type, size is 168.2KB.
The file 'IUninker Pi Case Din Rail Mount 3D Printer Model' is (stl) file type, size is 168.2KB.
Raspberry Pi Din rail mount for the iUniker Pi Case for 3B+
This mount was made for a PI being used in an industrial application. The cooling on this case is excellent.
Mount is 6 parts (1 Wide Din Mount, 1 Narrow Din Mount, 2 Narrow Pi Mount, @ Wide Pi Mount). The standoffs are 2 different widths. Longer Screws will be needed to go though the standoffs. Then stand offs are screwed to din rail pieces. Pieces are a tight fit and might need a bit of sanding with 2000 grit sand paper. Pay attention to the widths as the one closest to the Micro-sd card slot is thicker as are the corresponding standoffs.
Link to raspberry pi 3B+: https://www.microcenter.com/product/505661/raspberry-pi-3-model-b
Link to iUniker Case: https://www.amazon.com/dp/B07T3Z4RH4/ref=cm_sw_em_r_mt_dp_U_9IrcEbH890PRY
Longer Screws to go through standoffs into case: https://www.mcmaster.com/91292a835
Screws to mount stand off to Din rail mounts: https://www.mcmaster.com/95893a212
All parts printed with 30% infill. Recommend printing with PETG, But PLA should work.
| Body2.stl | 113.7KB | |
| Body3.stl | 110.5KB | |
| Body4.stl | 113.7KB | |
| Body5.stl | 110.5KB | |
| DIN_Rail_Cable_Clamp_v2.stl | 109.8KB | |
| DIN_Rail_Cable_Clamp_v2_1.stl | 116.2KB |
