YAIDHTLLARP0C (Yet Another 'It Doens't Have to Look Like a Raspberry Pi Zero Case)
This one is bigger and takes longer to print - over three hours.
The Pi slides in from underneath and sits flush with the table - also held into place by the power plug in the back (power, usb, micro HDMI in back).
There is an air vent in the top-back. Plus two air holes in the base that also help if your Pi Zero gets stuck. Just use needle-nose pliers a those points to gently pull it out.
I think it looks like a ram's head. The wife thinks it looks like McDonalds (don't tell Ronald)
P.S. There is a second .stl with an alternate top. I didn't print it because I didn't like it as much. Maybe you will.
My other Raspberry Pi Zero Cases:
http://www.thingiverse.com/thing:1597211
http://www.thingiverse.com/thing:1581003
http://www.thingiverse.com/thing:1587402
| RPi_Zero_Case_v6a.stl | 43.0KB | |
| RPi_Zero_Case_v6b.stl | 52.1KB |
