A lot of people liked my "It Doesn't Have to Look Like Raspberry Pi Zero Case" [http://www.thingiverse.com/thing:1581003], so I thought I'd try making one for the B+, 2B and 3 Pi's.
I did not realize it would turn out so HUGE!!
You can see it's relative size next to the Pi Zero case in the second photo, it is massive.
Still, it only takes around 25m of filament to print.
One of the reasons it is so tall is to make room at the bottom for the Enthernet and USB cables you might want to plug in.
Pi slides in from underneath and is held in place by friction and/or the power plug. And, again, with the chimney effect, it should help with airflow/cooling.
So, if you want something that looks...well, different sitting on your desk (or elsewhere) housing your Raspberry Pi Media Center, Gateway, IoT device, etc, maybe this is the case for you.
If nothing else, you'll get comments like "WTF is that?!?!?"
| RPi_2_Case-v10.stl | 230.9KB |
