I created this tray to catch the stray coffee grounds that fall from the grinder after I grind. It's low profile and the rubber legs of the grinder fit into recesses that hold it snugly in place.
It's a 3 part build that I split up to print on an Ender 3 without supports. Once the print is completed, glue the grinder base to the catcher base and then glue the back leg support to the grinder base (as the photo shows).
It's around a 5hr print on the Ender.
Mod the design as you see fit and improvements to the design are encouraged.
Happy printing.
| Coffee_Grinder_Base_v5.stl | 660.9KB | |
| Coffee_Grinder_Catcher_v5.stl | 69.4KB | |
| Coffee_Grinder_Rear_Legs_v5.stl | 120.6KB |
