The iPod cases I downloaded and tried where not fitting right in my son's iPod so I did this.
The patterns I used here can be downloaded in thingiverse.com/thing:33359 and thingiverse.com/thing:22568
This thing's OpenSCAD is too dirt and messy to upload it, sorry, just let me know if you would like to risk a headache and I may include it "as is".
For the logo I used a flatbed scanner and Inkscape to get a couple of DXF that are then used as shown in the OpenSCAD available for download.
Update Aug. 03 2013:
Uploaded a few test STL to allow a quick print and check and prevent having to waste time and material printing something that doesn't fit right. Thanks a lot to FherraZ for pointing this out!
| iFrame.dxf |
| iLogo.dxf |
| iP4_case.stl |
| iP4_gCarved.stl |
| iP4_gCarvedDual_Case.stl |
| iP4_gCarvedDual_Top.stl |
| iP4_gCase_150.stl |
| iP4_gCase_225.stl |
| iP4_gCase_500.stl |
| iP4_gSpots_150.stl |
| iP4_gSpots_225.stl |
| iP4_gSpots_500.stl |
| iP4_zCase.stl |
| iP4_zStripes.stl |
| iPod_4T_logo.scad |
| test_cap.stl |
| test_corners.stl |
| test_edges.stl |
| test_side.stl |
