Ipi Quadcopter – Racing Drone – 250 Type 3D Printer Model
The file 'Ipi Quadcopter – Racing Drone – 250 Type 3D Printer Model' is (STL) file type, size is 205.6KB.
The file 'Ipi Quadcopter – Racing Drone – 250 Type 3D Printer Model' is (STL) file type, size is 205.6KB.
This is my version of a nice racing drone though for begginers who keep crashing all the time.
https://www.youtube.com/watch?v=Xnum6L-rfKQ&feature=youtu.be
Features:
Low CDG - GoPro and batteries have been lowered to the middle plate. This also helps protecting the battery in the event of crash.
Arms have been designed in order to minimize the chances of breaking the motors.
If hitting the ground heavily, the arm should break through the weak point that can be observed in the pictures. Normally, when this happens, the motor starts to hang arround being held by only these weak conection points that attach the cable that comes from the esc to the motor.
I had one already broken due to this. To avoid it, two clamps on each arm hold the cables.
When breaking trough the weak point, the cover of the cable will help to absorve all the tension, avoiding the chance of breaking the conections.
Shock-absorbing landing gears
10º down-tilted fpv camera mount.
Electronics used on this dessign;
Emax 2204 motors - 2300KV
Emax 10A esc's
GensAce 1300 mAh 25C power battery
Tiger 480 mAh 25C fpv battery
CC3D openpilot flight control board
Stock power distribution board
Stock 700 TVL fpv camera
GoPro hero 3 black+ camera and cover
5030 propellers. Compatible up to 6030 props.
Stock buzzer
Boscam 600mW fpv video transmitter
| Arm.STL | 116.5KB | |
| Clamp.STL | 18.6KB | |
| Column_left.STL | 15.7KB | |
| Column_right.STL | 15.7KB | |
| Fpv_camera_support.STL | 45.8KB | |
| Gopro_mount.STL | 69.7KB | |
| Landing_gear.STL | 22.1KB | |
| Lower_plate.STL | 149.9KB | |
| Middle_plate.STL | 354.6KB | |
| Upper_plate.STL | 242.9KB |
