IPhone MagSafe Charging Tray: IPhone 13/14/15 (Pro/Plus/Max) 3D Printer Model
The file 'IPhone MagSafe Charging Tray: IPhone 13/14/15 (Pro/Plus/Max) 3D Printer Model' is (stl) file type, size is 361.3KB.
The file 'IPhone MagSafe Charging Tray: IPhone 13/14/15 (Pro/Plus/Max) 3D Printer Model' is (stl) file type, size is 361.3KB.
This is a charging tray intended to be used with the MagSafe charger for the iPhone 13/14/15 regular/Pro/Plus/Pro Max models. I designed it to make it dead simple for the MagSafe puck to stick to the back of the iPhone and I made it large enough so it can be used with almost any case. You can just toss your phone onto the tray and the beveled edges help ensure the phone slides into place. The bottom of the tray has cut-outs for the cable in any direction: top, bottom, left or right so you can pick the best orientation for you. It can be a little tight getting the cable in there, but it will fit. There are also cut-outs for .5" rubber pads. I found some on Amazon that I linked below (or just search for .5" rubber pads).
Make sure to download the correct model for your phone. There is one for the 6.1" regular iPhone, the 6.1" iPhone Pro, and the 6.7" iPhone Pro Max and iPhone Plus (same model).
I recommend printing them with 100% infill, completely solid. This is to make the printed tray is as heavy as possible so the phone comes away from the charing puck as easily as possible.
I printed some for my wife and daughter who put little vinyl stickers in the camera cut-out. :)
Amazon Rubber .5" Pads Link:
https://a.co/d/iNpqe6r
| iPhoneMagSafeChargingTray.stl | 448.6KB | |
| iPhoneProMagSafeChargingTray.stl | 436.2KB | |
| iPhoneProMaxPlusMagSafeChargingTray.stl | 512.3KB |
