Print with little support, and print it laying down. Should go easy, this one is made out of ABS.
Inside measurement is 82mm (fits an iPhone PLUS with a thin sleeve or bumper!) so can fit any phone with that measurement. The 4 holes are made for tiewraps, put them through your vent and pull them through the center hole. You can also cut them there. The tiewrap holes are sinked into the design so they don't interfere with your phone placement.
It's a very sturdy mount and looks quite nice I think ;)
Make one? Show me!
| iphone_7_vent_holder.stl | 88.9KB |
